AIRPLANE CANOPY CERAMIC COAT CNP
HENDLEX CNP is nano ceramic coating, specially designed and tested for airplane canopy. Coating renews the surface, provides high water repellency, less air friction, and easy bugs removal properties, coating is especially sturdy and durable, safe to use and has no side effects for airplane.
This coating can be applied on plastic airplane canopy. CNP nano ceramic coating does not chap in the air even if there is high level of airplane body vibration.
PACKED UNDER INERT GAS. Guarantee 100% effectiveness.
- Less rain drops during the rain;
- Renews surface;
- Less air friction;
- Easy bugs removal;
- Less holograms and minor scratches;
- Long lasting;
- The coating is resistant to temperature range from -30 °C to +150 °C.
Application surfaces – Airplane canopy
Covered area – 20 ml for 8 m2
Durability – 2-5 years, depending on weathering conditions
Coating properties – Water and dirt repellency, surface renewal, protection from corrosion, less air friction.
Shelf life – 1 year without opening the bottle
Thermal resistance – -30 °C to +150 °C
Chemical resistance – 3<pH<12
Coating thickness – <900 nm
Hardness – 9H pencil
Water contact angle – 106°
Application temperature – +10 °C to +25 °C (recommended +20 °C)
Curing period – 24 hours initial, 7 days final
Storage conditions – +5 °C to +25 °C
Packaging – 20 ml aluminum bottle. Packed under inert gas
If airplane is waxed, remove wax with HENDLEX Wax Remover. Wash the airplane carefully and make sure there are no washing products (shampoos, dirt, solvents) left on the surface.
For better result it is recommended to coat polished airplane canopy surface. After polishing make sure to wash the airplane canopy. It is recommended to remove the remaining water using the compressed air jet.
It is also recommended to clean the surface with HENDLEX Paint Prepare.
The proper temperature for coating is from +10 °C to +25 °C. Cover the surface evenly and make sure that you did not leave uncovered spots.
If the temperature is lower than +20 °C the surface must be polished in 30 seconds after coverage. If the temperature is higher than +24 °C the surface must be polished in 20 seconds after coating application. If the surface gets into contact with water, immediately clean it and repeat the coating process.
Adhesive tape does not stick on the coated surface. Do not coat CNP ceramic coating on the surface where adhesive tape will be applied.
Recommended coating curing period:
- if the temperature is higher than +22°C – 12 hours initial;
- if the temperature is +20°C – 24 hours initial;
- if the temperature is less than +18°C – need to use IR lamps (+60°C – +80°C) for at least 1 hour.
Do not wash the airplane canopy for 7 days. Depending on the environment temperature, the coating fully hardens in 7 days.
20 ml for 8 m2.